Abstract:
Poly (3-hexylthiophene) (P3HT) and phenyl-C61-butyric acid methyl ester (PCBM) bulk
heterojunction solar cells are of immense interest due to their potential towards fabrication of flexible and
low-cost solar cells using simple solution process techniques. The role of hole-blocking layer (HBL) is vital
in the inverted device structure. In this work, we investigated the effect of Titanium dioxide (TiO2) and
Cadmium sulfide (CdS) thin films as the hole blocking layer on the performance of the P3HT:PCBM solar
cells. TiO2 and CdS thin films with same thickness were fabricated by using simple chemical bath deposition
and spray pyrolysis respectively 1–4. Solar cells were fabricated on the fabricated HBL by spin coating a
chlorobenzene (CB) solution of P3HT: PCBM (1:1 by weight) containing 25 mg/ml P3HT and 25 mg/ml
PCBM. Solar cells fabricated with TiO2 as HBL showed better short circuit current density (Jsc) when
compare to CdS devices. However, the overall power conversion efficiency (PCE) is higher for the devices
with CdS as HBL predominantly due to higher Voc and fill factor. The increased Voc of the CdS devices was
due to higher valence band position of CdS when compare to TiO2 from the vacuum level. The detail results
and the mechanism behind the improved PCE of the CdS based devices will be discussed in the
presentation.
