Abstract:
Perovskite solar cells (PSCs) have been emerged as a strong contender for the next generation of
photovoltaic technologies due to their promising power conversion efficiency (PCE) along with high
absorbance, low-cost of production and facile fabrication process of absorber and Nanocrystalline TiO2
layers. This study focuses on optimizing the performance of PSCs by modifying the active layers by varying
the thickness of the active layers and the reaction time for the perovskite precursor solution. The
corresponding ITO /compact TiO2 / mesoporous TiO2 / CH3NH3PbIxCl3-x / P3HT / Au devices were fabricated.
Mesoporous TiO2 (mp-TiO2) layer was deposited by solution processed spin coating method. Various spin
rates and different concentrations of transparent Titania (18NR-T) nanocolloidal paste dissolved in
Tetrahydrofuran (THF) were investigated for optimizing mp-TiO2 layer with five different thickness of 400
nm, 500 nm, 600 nm, 750 nm and 950 nm. The best efficiency of 8.6 % was achieved with mp-TiO2 thickness
of 400 nm. Two different reaction times were investigated to identify the optimum reaction time for the
perovskite precursor solution, and the device with reaction a time of 8 hours exhibited efficiency of over
3%, whereas the best efficiency of 6.4 % was achieved for the one fabricated with the reaction time of
2 hours. Furthermore, thin layers of perovskite with 400 nm thickness of TiO2 exhibited better performance
than the devices fabricated with the TiO2 layer thickness of 550 nm. All the measurements were carried
out under Air Mass (AM) 1.5 conditions (100 mW cm−2, 1 sun) in air.
